How to install led light bar?

1.)Connectthe LED work light bar to a 12v bench tester or directly toyour vehicle's car battery to check if the product works prior to installing onyour vehicle.

2.) Using the provided screws (3/4") andrubber washers attach the mounting bracket to both ends of the LED light barand tighten with an allen wrench.

3.) Locate the position where you want toinstall the LED light bar and use the 1.25" screws and bolts to secure thelight bar to the vehicle.

NOTE: Be advised that the product is designed tobe installed on a flat surface only. If mounting the product on a curved oruneven surface, we recommend using self-tapping screws instead for a betterinstallation.

4.) Once the light bar is mounted, route thewires from the product to the relay switch. Connect the red wire to the redwire on the switch and black wire to the black wire on the switch. (Werecommend soldering the connections or using butt-connectors and covering anyexposed wires with electrical tape or heat shrink tubing).

5.) Route the red and black wires from the relayswitch directly to the battery positive and negative (red for positive andblack for negative).